DisksAvailable disk destinations depend on the agents operating on the machine. Recover to: Physical machine Available when the Acronis Backup & Recovery 10 Agent for Windows or Agent for Linux is installed. The selected disks will be recovered to the physical disks of the machine the console is connected to. On selecting this, you proceed to the regular disk mapping procedure described below. If Acronis Backup & Recovery 10 Agent for Windows is installed. The selected disks will be recovered to a new virtual machine of any of the following types: VMware Workstation, Microsoft Virtual PC, Parallels Workstation or Citrix XenServer Open Virtual Appliance (OVA). The virtual machine files will be saved to the destination you specify. If Acronis Backup & Recovery 10 Agent for Hyper-V or Agent for ESX/ESXi is installed. These agents enable creating a new virtual machine on the virtualization server you specify. The new virtual machine will be configured automatically, the source machine configuration being copied where possible. The configuration is displayed in the Virtual Machine Settings section. Check the settings and make changes if necessary. Then you proceed to the regular disk mapping procedure described below. Existing virtual machine Available when the Acronis Backup & Recovery 10 Agent for Hyper-V or Agent for ESX/ESXi is installed. On selecting this, you specify the virtualization server and the target virtual machine. Then you proceed to the regular disk mapping procedure described below. Please be aware that the target machine will be powered off automatically before the recovery. If you prefer to power it off manually, modify the VM power management option. Disk #: Select the destination disk for each of the source disks. Select the way the recovered disk’s signature will be handled. The disk signature is used by Windows and the Linux kernel version 2.6 and later. |